Structurepoint

Upgraded to ACI 318-14 and CSA A23.3-14, spColumn v5.10 is widely used for design of shear walls, bridge piers as well as typical framing elements in buildings and structures. Formerly pcaColumn, PCACOL, and IrrCOL, spColumn investigates sections that are impossible to find on design charts or to do by hand.

spBeam is structural engineering software for the analysis, design, and detailing of reinforced concrete one-way slab systems, continuous beams, and joist systems (including standard and wide module configurations).

spColumn is structural engineering software for designing and investigating reinforced concrete sections subject to combined axial and flexural loads.

spSlab is structural engineering software for the analysis, design and detailing of reinforced concrete two-way slab systems, one-way slab systems, continuous beams, waffle slabs, and slab bands.

spWall is a computer program for design and analysis of reinforced concrete cast-in-place walls, tilt-up walls, ICF walls, and precast architectural and load-bearing panels. It uses a graphical interface that enables the user to easily generate complex wall models. The geometry of the wall (including any number of openings and siffeners), the material properties, the loads (point, line, and area), and the support conditions are assigned graphically by the user. Also, springs (translational and rotational) can be graphically assigned at any node.